Cisco ME 3400 Software Configuration Manual page 891

Chapter 39 Configuring Cisco IOS IP SLAs Operations
Beginning in privileged EXEC mode, follow these steps to configure UDP jitter operation on the source
device:
Command
Step 1 configure terminal
Step 2
ip sla operation-number
Step 3
udp-jitter {destination-ip-address
| destination-hostname}
destination-port [source-ip
{ip-address | hostname}]
[source-port port-number]
[control {enable | disable}]
[num-packets number-of-packets]
[interval interpacket-interval]
Step 4 frequency seconds
Step 5 exit
OL-9639-07
Purpose
Enter global configuration mode.
Create an IP SLAs operation, and enter IP SLAs configuration mode.
Configure the IP SLAs operation as a UDP jitter operation, and enter UDP
jitter configuration mode.
• destination-ip-address | destination-hostname—Specify the destination IP
address or hostname.
• destination-port—Specify the destination port number in the range from 1
to 65535.
(Optional) source-ip {ip-address | hostname}—Specify the source IP
•
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination
(Optional) source-port port-number—Specify the source port number in
•
the range from 1 to 65535. When a port number is not specified, IP SLAs
chooses an available port.
(Optional) control—Enable or disable sending of IP SLAs control
•
messages to the IP SLAs responder. By default, IP SLAs control messages
are sent to the destination device to establish a connection with the IP
SLAs responder
(Optional) num-packets number-of-packets—Enter the number of
•
packets to be generated. The range is 1 to 6000; the default is 10.
(Optional) interval inter-packet-interval—Enter the interval between
•
sending packets in milliseconds. The range is 1 to 6000; the default value
is 20 ms.
(Optional) Set the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 seconds.
Exit UDP jitter configuration mode, and return to global configuration mode.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring IP SLAs Operations
39-9