Uploading A Configuration File By Using Rcp; Clearing Configuration Information - Cisco ME 3400 Software Configuration Manual

Working with Configuration Files

Uploading a Configuration File By Using RCP

Beginning in privileged EXEC mode, follow these steps to upload a configuration file by using RCP:
Command
Step 1
Step 2
Step 3 configure terminal
Step 4 ip rcmd remote-username username
Step 5 end
Step 6
copy system:running-config
rcp:[[[//[username@]location]/directory]/filename]
or
copy nvram:startup-config
rcp:[[[//[username@]location]/directory]/filename]
This example shows how to copy the running configuration file named switch2-confg to the netadmin1
directory on the remote host with an IP address of 172.16.101.101:
Switch# copy system:running-config rcp://netadmin1@172.16.101.101/switch2-confg
Write file switch-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
Switch#
This example shows how to store a startup configuration file on a server:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin2
Switch(config)# end
Switch# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [switch2-confg]?
Write file switch2-confg on host 172.16.101.101?[confirm]
![OK]

Clearing Configuration Information

You can clear the configuration information from the startup configuration. If you reboot the switch with
no startup configuration, the switch enters the setup program so that you can reconfigure the switch with
all new settings.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
B-18
Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Purpose
Verify that the RCP server is properly configured by
referring to the
Configuration File By Using RCP" section on page
Log into the switch through the console port or a Telnet
session.
Enter global configuration mode.
This step is required only if you override the default remote
username (see Steps 4 and 5).
(Optional) Specify the remote username.
Return to privileged EXEC mode.
Using RCP, copy the configuration file from a switch running
or startup configuration file to a network server.
"Preparing to Download or Upload a
B-16.
OL-9639-07