Vlan Maps And Router Acl Configuration Guidelines - Cisco ME 3400 Software Configuration Manual

Using VLAN Maps with Router ACLs
If the VLAN map has a match clause for the type of packet (IP or MAC) and the packet does not match
the type, the default is to drop the packet. If there is no match clause in the VLAN map, and no action
specified, the packet is forwarded if it does not match any VLAN map entry.
These sections contain information about using VLAN maps with router ACLs:
•
•

VLAN Maps and Router ACL Configuration Guidelines

These guidelines are for configurations where you need to have an router ACL and a VLAN map on the
same VLAN. These guidelines do not apply to configurations where you are mapping router ACLs and
VLAN maps on different VLANs.
The switch hardware provides one lookup for security ACLs for each direction (input and output);
therefore, you must merge a router ACL and a VLAN map when they are configured on the same VLAN.
Merging the router ACL with the VLAN map might significantly increase the number of ACEs.
If you must configure a router ACL and a VLAN map on the same VLAN, use these guidelines for both
router ACL and VLAN map configuration:
•
•
•
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
31-36
VLAN Maps and Router ACL Configuration Guidelines, page 31-36
Examples of Router ACLs and VLAN Maps Applied to VLANs, page 31-37
You can configure only one VLAN map and one router ACL in each direction (input/output) on a
VLAN interface.
Whenever possible, try to write the ACL with all entries having a single action except for the final,
default action of the other type. That is, write the ACL using one of these two forms:
permit...
permit...
permit...
deny ip any any
or
deny...
deny...
deny...
permit ip any any
To define multiple actions in an ACL (permit, deny), group each action type together to reduce the
number of entries.
Avoid including Layer 4 information in an ACL; adding this information complicates the merging
process. The best merge results are obtained if the ACLs are filtered based on IP addresses (source
and destination) and not on the full flow (source IP address, destination IP address, protocol, and
protocol ports). It is also helpful to use don't care bits in the IP address, whenever possible.
If you need to specify the full-flow mode and the ACL contains both IP ACEs and TCP/UDP/ICMP
ACEs with Layer 4 information, put the Layer 4 ACEs at the end of the list. This gives priority to
the filtering of traffic based on IP addresses.
Chapter 31 Configuring Network Security with ACLs
OL-9639-07