Enabling E-Lmi - Cisco ME 3400 Software Configuration Manual

Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Use the no forms of the commands to delete an EVC, EFP, or UNI ID, or to return to default
configurations.
If you configure, change, or remove a UNI service type, EVC, EFP, or CE-VLAN configuration, all
Note
configurations are checked to make sure that the configurations match (UNI service type with EVC or
EFP and CE-VLAN configuration). The configuration is rejected if the configurations do not match.

Enabling E-LMI

You can enable E-LMI globally or on an interface and you can configure the switch as a PE or a CE
device. Beginning in privileged EXEC mode, follow these steps to enable for E-LMI on the switch or on
an interface. Note that the order of the global and interface commands determines the configuration. The
command that is entered last has precedence.
Command
Step 1 configure terminal
Step 2 ethernet lmi global
Step 3
ethernet lmi ce
Step 4
interface interface-id
Step 5 ethernet lmi interface
OL-9639-07
Purpose
Enter global configuration mode.
Globally enable E-LMI on all interfaces. By default, the
switch is a PE device.
(Optional) Configure the switch as an E-LMI CE device.
Define an interface to configure as an E-LMI interface, and
enter interface configuration mode.
Configure Ethernet LMI on the interface. If E-LMI is
enabled globally, it is enabled on all interfaces unless you
disable it on specific interfaces. If E-LMI is disabled
globally, you can use this command to enable it on
specified interfaces.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring E-LMI
41-29