Policing - Cisco ME 3400 Software Configuration Manual

Understanding QoS
This example creates a table to map specific CoS values to DSCP values. The default command maps
all unmapped CoS values to a DSCP value of 63.
Switch(config)# table-map cos-dscp-tablemap
Switch(config-tablemap)# map from 5 to 46
Switch(config-tablemap)# map from 6 to 56
Switch(config-tablemap)# map from 7 to 57
Switch(config-tablemap)# default 63
Switch(config-tablemap)# exit
The switch supports a maximum of 256 unique table maps. You can enter up to 64 different map from–to
entries in a table map. These table maps are supported on the switch:
•
•
•
•
•
•
•
•
•
Table maps modify only one parameter (CoS, IP precedence, or DSCP, whichever is configured) and are
only effective when configured with a set command in a policy map or with a conform-action or
exceed-action command in a police function.
Table maps are not supported in output policy maps. For more information, set the
Maps" section on page

Policing

After a packet is classified, you can use policing as shown in
The policing function limits the amount of bandwidth available to a specific traffic flow or prevents a
traffic type from using excessive bandwidth and system resources. A policer identifies a packet as in or
out of profile by comparing the rate of the inbound traffic to the configuration profile of the policer and
traffic class. Packets that exceed the permitted average rate or burst rate are out of profile or
nonconforming. These packets are dropped or modified (marked for further processing), depending on
the policer configuration.
Policing is used primarily on receiving interfaces. You can attach a policy map with a policer only in an
input service policy. The only policing allowed in an output policy map is in priority classes. See the
"Unconditional Priority Policing" section on page
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
33-14
DSCP to CoS
DSCP to precedence
DSCP to DSCP
CoS to DSCP
CoS to precedence
CoS to CoS
Precedence to CoS
Precedence to DSCP
Precedence to precedence
33-36.
Figure 33-5 to regulate the class of traffic.
33-18.
Chapter 33 Configuring QoS
"Configuring Table
OL-9639-07