Adding And Removing Static Address Entries - Cisco ME 3400 Software Configuration Manual

Chapter 5 Administering the Switch

Adding and Removing Static Address Entries

A static address has these characteristics:
•
•
•
You can add and remove static addresses and define the forwarding behavior for them. The forwarding
behavior defines how a port that receives a packet forwards it to another port for transmission. Because
all ports are associated with at least one VLAN, the switch acquires the VLAN ID for the address from
the ports that you specify. You can specify a different list of destination ports for each source port.
A packet with a static address that arrives on a VLAN where it has not been statically entered is flooded
to all ports and not learned.
You add a static address to the address table by specifying the destination MAC unicast address and the
VLAN from which it is received. Packets received with this destination address are forwarded to the
interface specified with the interface-id option.
When you configure a static MAC address in a private-VLAN primary or secondary VLAN, you should
also configure the same static MAC address in all associated VLANs. Static MAC addresses configured
in a private-VLAN primary or secondary VLAN are not replicated in the associated VLAN. For more
information about private VLANs, see
Beginning in privileged EXEC mode, follow these steps to add a static address:
Command
Step 1 configure terminal
Step 2
mac address-table static mac-addr
vlan vlan-id interface interface-id
Step 3 end
Step 4
show mac address-table static
Step 5 copy running-config startup-config
To remove static entries from the address table, use the no mac address-table static mac-addr vlan
vlan-id [interface interface-id] global configuration command.
OL-9639-07
It is manually entered in the address table and must be manually removed.
It can be a unicast or multicast address.
It does not age and is retained when the switch restarts.
Purpose
Enter global configuration mode.
Add a static address to the MAC address table.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 12, "Configuring Private VLANs."
• For mac-addr, specify the destination MAC unicast address to add to
the address table. Packets with this destination address received in the
specified VLAN are forwarded to the specified interface.
For vlan-id, specify the VLAN for which the packet with the
•
specified MAC address is received. Valid VLAN IDs are 1 to 4094;
do not enter leading zeros.
For interface-id, specify the interface to which the received packet is
•
forwarded. Valid interfaces include physical ports or port channels.
For static multicast addresses, you can enter multiple interface IDs.
For static unicast addresses, you can enter only one interface at a
time, but you can enter the command multiple times with the same
MAC address and VLAN ID.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Managing the MAC Address Table
5-25