Manually Configuring An Ip Slas Cfm Probe Or Jitter Operation - Cisco ME 3400 Software Configuration Manual

Configuring Ethernet CFM
This section includes these procedures:
•
•

Manually Configuring an IP SLAs CFM Probe or Jitter Operation

Beginning in privileged EXEC mode, follow these steps to manually configure an IP SLAs Ethernet echo
(ping) or jitter operation:
Command
Step 1 configure terminal
Step 2
ip sla operation-number
Step 3
ethernet echo mpid identifier domain domain-name
vlan vlan-id
or
ethernet jitter mpid identifier domain domain-name
vlan vlan-id [interval interpacket-interval]
[num-frames number-of frames transmitted]
Step 4 cos cos-value
Step 5 frequency seconds
Step 6 history history-parameter
Step 7 owner owner-id
Step 8 request-data-size bytes
Step 9 tag text
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
41-10
Manually Configuring an IP SLAs CFM Probe or Jitter Operation, page 41-10
Configuring an IP SLAs Operation with Endpoint Discovery, page 41-12
Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Purpose
Enter global configuration mode.
Create an IP SLAs operation, and enter IP SLAs
configuration mode.
Configure the IP SLAs operation as an echo (ping) or jitter
operation, and enter IP SLAs Ethernet echo configuration
mode.
Enter echo for a ping operation or jitter for a jitter
•
operation.
For mpid identifier, enter a maintenance endpoint
•
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
For domain domain-name, enter the CFM domain
•
name.
For vlan vlan-id, the VLAN range is from 1 to 4095.
•
(Optional—for jitter only) Enter the interval between
•
sending of jitter packets.
(Optional—for jitter only) Enter the num-frames and
•
the number of frames to be sent.
(Optional) Set a class of service value for the operation.
(Optional) Set the rate at which the IP SLAs operation
repeats. The range is from 1 to 604800 seconds; the default
is 60 seconds.
(Optional) Specify parameters for gathering statistical
history information for the IP SLAs operation.
(Optional) Configure the SNMP owner of the IP SLAs
operation.
(Optional) Specify the protocol data size for an IP SLAs
request packet. The range is from 0 to the maximum size
allowed by the protocol being used; the default is 66 bytes.
(Optional) Create a user-specified identifier for an IP SLAs
operation.
OL-9639-07