Cisco ME 3400 Software Configuration Manual page 828

Configuring Protocol-Independent Features
Command
Step 21
set weight
Step 22
end
Step 23 show route-map
Step 24 copy running-config startup-config
To delete an entry, use the no route-map map tag global configuration command or the no match or no
set route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
Command
Step 1
configure terminal
Step 2
router {bgp | rip | ospf | eigrp}
Step 3 redistribute protocol [process-id] {level-1 | level-1-2 |
level-2} [metric metric-value] [metric-type type-value]
[match internal | external type-value] [tag tag-value]
[route-map map-tag] [weight weight] [subnets]
Step 4
default-metric number
Step 5 default-metric bandwidth delay reliability loading mtu
Step 6 end
Step 7
show route-map
Step 8
copy running-config startup-config
To disable redistribution, use the no form of the commands.
The metrics of one routing protocol do not necessarily translate into the metrics of another. In these
situations, an artificial metric is assigned to the redistributed route. Uncontrolled exchanging of routing
information between different routing protocols can create routing loops and seriously degrade network
operation.
If you have not defined a default redistribution metric that replaces metric conversion, some automatic
metric translations occur between routing protocols:
•
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
35-102
RIP can automatically redistribute static routes. It assigns static routes a metric of 1 (directly
connected).
Any protocol can redistribute other routing protocols if a default mode is in effect.
Chapter 35
Purpose
Set the BGP weight for the routing table. The value can
be from 1 to 65535.
Return to privileged EXEC mode.
Display all route maps configured or only the one
specified to verify configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter router configuration mode.
Redistribute routes from one routing protocol to
another routing protocol. If no route-maps are
specified, all routes are redistributed. If the keyword
route-map is specified with no map-tag, no routes are
distributed.
Cause the current routing protocol to use the same
metric value for all redistributed routes (BGP, RIP and
OSPF).
Cause the EIGRP routing protocol to use the same
metric value for all non-EIGRP redistributed routes.
Return to privileged EXEC mode.
Display all route maps configured or only the one
specified to verify configuration.
(Optional) Save your entries in the configuration file.
Configuring IP Unicast Routing
OL-9639-07