Debug Platform Sw-Bridge - Cisco WS-C3560E-24PD-E Command Reference Manual

debug platform sw-bridge

debug platform sw-bridge
Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
Syntax Description
broadcast
control
multicast
packet
unicast
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(19)EA1
Usage Guidelines
The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
Related Commands Command
show debugging
Catalyst 3560 Switch Command Reference
B-64
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
Display broadcast-data debug messages.
Display protocol-packet debug messages.
Display multicast-data debug messages.
Display sent and received data debug messages.
Display unicast-data debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3560 Switch Debug Commands
78-16405-05