Installation - Austroflamm Ruby 2.0 Operating Manual

Operating manual Ruby 2.0
9

Installation

The assembly and installation must only be carried out by an authorized specialist company.
Before installing the pellet stove, check that all movable parts are working. Any defects must be repor-
ted before installing the pellet stove.
Observe regionally applicable safety and construction regulations and contact your master chimney
sweep in this regard.
Use only heat-resistant sealing materials, sealing tape, heat-resistant silicon and mineral wool.
Make sure that the flue pipe is not blocking the free cross-section of the chimney.
If your pellet stove is provided for balanced flue operation, the stove pipe connections must be con-
nected permanently tightly. Use suitable heatproof silicon for placing the stove pipe on to the conical
flue pipe brackets and for inserting into the chimney's pipe chuck.
On no account position the pellet stove on unprotected floor. Corrugated board, cardboard or a dis-
used carpet are suitable for use as an assembly aid and base. These allow you to move the pellet stove
carefully.
For proper installation we recommend original flue pipes from our Austroflamm flue pipe range.
In the following sections we will give you information on
• the integration or attachment of appliance parts,
• other important facts relating to the installation.
The protective equipment and tools listed are required for the following work steps
Type of protective equipment
Work equipment
Insulated tools
Torx wrench set
Allen key set
Fork wrench set
EN
Safety gloves
Safety shoes
Activity
In order not to damage or scratch the varnish, no sharp
objects or tools should be used. Instead insulated tools
are used by preference when assembling and disas-
sembling stove parts.
Various installation jobs
Various installation jobs
Various installation jobs
9 | Installation
23