Austroflamm Ruby 2.0 Operating Manual page 65

Operating manual Ruby 2.0
LED "CONT"
1) Blinking (0.5 sec. ON/0.5 sec. OFF): Establishing communication with the heating appliance.
2) Continuously ON: Communication established with the heating appliance.
LED "STATUS"
1) Blinking (0.5 sec. ON/0.5 sec. OFF): Establishing connection to the server.
2) Slow blinking (1 sec. ON/1 sec. OFF): Setting up cloud functionalities (after successfully connect-
ing the appliance to the cloud server).
3) Continuously ON: ready for operation by remote access via App.
LED "SETUP WIFI RESET"
1) Rapid blinking (0.25 sec. ON/0.25 sec. OFF): Pressing the "SETUP WIFI RESET" button switches
the WLAN Box into "WLAN network mode". In this mode the WLAN Box looks for available
WLAN networks and enables connection to a network.
2) Blinking (0.5 sec. ON/0.5 sec. OFF): Creating connection to the Access Point.
3) Slow blinking (1 sec. ON/1 sec. OFF): Acquiring the IP address (after creating the connection to
the Access Point).
4) Continuously lit: Communication with the WLAN router has been created.
9.1.6.6 Functions and operations of the Austroflamm PelletControl APP
NOTICE
You will only have all the functions of the WLAN Box and the Austroflamm PelletControl APP if the
WLAN Box has the current software and the current AUSTROFLAMM PELLET CONTROL APP-VER-
SION is loaded on your Smart device.
EN 9 | Installation
65