Maintenance Mode Window - Omron E5ZN-DRT Operation Manual

Maintenance Mode Window

Setting Method
1,2,3...
5-3

Maintenance Mode Window

5-3-1

Maintenance Mode Window

1. Open the Edit Unit Parameters Window, select the monitor mode to be
used, Conduction Time or RUN Time, under the Detection Mode, and enter
the monitoring time in the Value field.
2. Click the OK Button to return to the Edit Device Parameters Window.
Note All the settings will be cleared if the Cancel Button or
used to exit the window. Always click the OK Button to exit the win-
dow.
3. To continue setting monitor values for other Temperature Controllers, re-
peat the procedure from step 1.
4. After setting monitor values for each Temperature Controller, return to the
General Tab Page and click the Download Button to write the monitor val-
ues for all the Temperature Controllers to the DeviceNet Communications
Unit in a batch.
The OMRON DeviceNet Configurator (Ver. 2.20 or later) is provided with two
Network display windows, consisting of the standard Main Window and a
Maintenance Mode Window, enabling DeviceNet status information to be
checked easily.
The Maintenance Mode Window is different from the Main Window and is
used to easily monitor the Network status and the status of each node.
In the Network Configuration Window of the Maintenance Mode Window,
when an error is detected in a node, a yellow warning icon is displayed next to
the corresponding node icon, enabling errors to be checked immediately.
By double-clicking on a node in the Network Configuration Window of the
Maintenance Mode Window, the Maintenance Information Window is dis-
played, and the status of the node can be checked.
The Maintenance Mode Window is displayed with a pale blue background.
Section 5-3
Button is
83