Omron E5ZN-DRT Operation Manual page 64

Allocating I/O from the Configurator
5. Create Allocation Data for the IN Area
Create the allocation data for the IN Area in the IN Allocations Tab Page.
Select the parameters to be allocated from the list in the Parameters field
(top half of window), and drag to the corresponding word in the Allocation
Area field (bottom half of window). Allocations can also be performed using
the Allocate Button in the same way as for the OUT Area.
Note a) When using a CS/CJ-series DeviceNet Unit as the master, the IN
Area can be divided into two separate areas. When allocating da-
ta, drag the parameter to either the IN Area field on the left or right
(Allocated Area 1, Allocated Area 2). To create these two areas,
however, two connections must be defined by the user between
the master and DeviceNet Communications Unit on the Edit De-
vice Parameters Window for the master. For details, refer to Set-
ting Connections when Dividing IN Area in Two under 4-4-2 User-
set Allocations.
b) Parameters indicated by a grayed-out icon (
ed. Data for some types of Temperature Controller cannot be allo-
cated.
c) Do not allocate the same parameter more than once (same pa-
rameter for the same channel of the same Temperature Control-
ler).
6. Return to the General Tab, and click the Download Button. The device pa-
rameters (connection configuration, allocation data) will be registered in
the DeviceNet Communications Unit.
7. Always click the OK Button to exit the Edit Device Parameters Window.
Section 4-3
) cannot be allocat-
49