Omron E5ZN-DRT Operation Manual page 141

Maintenance
Read Setting Parameters
(Upload)
1,2,3...
126
3. Pulse output models refer to the E5ZN-2Q
type, and the E5ZN-2T
models refer to the E5ZN-2C
Use this function to upload the setting parameters from the Temperature Con-
trollers to the DeviceNet Communications Unit.
DeviceNet
Communications
Unit
Execution Condition
There can be no communications error (TS indicator is not flashing red).
Procedure
1. Turn OFF pin 2 (upload) of the DIP switch on the front of the DeviceNet
Communications Unit.
2. Toggle pin 1 of the of the DIP switch on the front of the DeviceNet Commu-
nications Unit from OFF to ON (leave ON for 1 to 5 seconds) and then turn
OFF again (while pin 1 is ON, the TS indicator will be lit green). The data
will start uploading and the TS indicator will flash green.
Copy operation mode setting
Execution Results
• If the uploading completes normally, the TS indicator status will return to
be lit green.
• If the upload operation ends abnormally, after error completion, the TS
indicator will flash red for 10 seconds.
Note 1. For the upload operation, when pin 1 (copy) is turned ON, and then OFF
again, the TS indicator will flash green. Check that the TS indicator is flash-
ing green during the upload operation.
2. To cancel an upload operation, leave pin 1 (copy) ON for at least 5 sec-
onds, and then turn OFF again.
H03 -FLK transistor output type. Analog output
@ @
H03
@ @
Uploading
UNIT UNIT UNIT UNIT
BPS BPS BPS BPS
POWER POWER POWER POWER
ERROR ERROR
ERROR ERROR
SD/RD SD/RD SD/RD SD/RD
OUT1 OUT1 OUT1 OUT1
OUT2 OUT2 OUT2 OUT2
SUB1 SUB1
SUB1 SUB1
SUB2 SUB2 SUB2 SUB2
E5ZN E5ZN E5ZN E5ZN E5ZN
Temperature Controllers
ON
UP/DN
Start copying
COPY
Turn OFF
pin 2
Indicators
Lit green
Section 8-2
H03 -FLK voltage output
@ @
-FLK current output types.
Leave pin 1 ON
for 1 to 5 s
Lit green Flashing green
TS