Omron E5ZN-DRT Operation Manual page 43

Installation
Mounting the Unit
Removing the Unit
Mounting End Plates
28
Pull down the DIN Track mounting hook on the bottom of the Unit (1), latch the
top hook on the back of the Unit onto the track (2), push the Terminal Unit until
the hook can be locked onto the track (3), and then push the DIN Track mount-
ing hook back up to lock the Unit in place (4).
2
3
1
Use a flat-blade screwdriver to pull down the DIN Track mounting hook, and
then pull out the bottom of the Terminal Unit.
Always mount end plates to both ends to keep the Terminal Units connected
together.
Hook the bottom of the end plate onto the DIN Track (1), hook the top, and
then pull down (2). Secure the end plate screws.
UNIT
UNIT
BPS
BPS
POWER POWER
ERROR ERROR
SD/RD SD/RD
OUT1 OUT1
OUT2 OUT2
SUB1
SUB1
SUB2 SUB2
E5ZN E5ZN E5ZN
Note Always use two End Plates to clamp the Units together from both ends.
4
(2)
(1)
Section 3-2