Installation
3-2-2
Mounting to DIN Track
Mounting Bracket
PFP-50N (50 cm)/PFP-100N (100 cm) DIN Track
PFP-M End Plates ( 2)
Mounting Direction
Attach a connector cover (included with the Terminal Unit) to the unused con-
nector of the rightmost Terminal Unit. This measure will prevent dust and dirt
from entering the Unit.
Note Terminal Units can be joined together by simply connecting the connectors to
each other, and can be disconnected again by simply pulling them apart.
Mount the DeviceNet Communications Unit and Temperature Controllers to
the DIN Track.
Use screws to attach the DIN Track to the control panel in at least three
places.
The mounting direction of the Temperature Controllers is fixed. Position the
DIN track vertical to the ground, as shown in the following diagram.
Vertical: OK
Horizontal: NG
Connector cover
Section 3-2
27