Omron E5ZN-DRT Operation Manual page 29

Initial Temperature Controller Settings
Setting with Remote I/
O Communications
Setting with Explicit
Messages
DeviceNet
Communications Unit
14
Set the parameters from the PLC with the master using remote I/O communi-
cations.
PLC
DeviceNet
Communications Unit
Set the initial settings from the PLC with the master by sending an explicit
message.
PLC
CMN D
CM ND
(1) Execute a command to shift to setting area 1.
SET
(2) Set the parameters in variable area C3.
MO V
(1) Send a command to shift to setting area 1.
(Operation command 30 05, command code 07)
(2) Set the parameters in variable area C3.
(VARIABLE AREA WRITE 01 02, variable type C3).
Section 1-4