Parameter List - Omron E5ZN-DRT Operation Manual

Allocating I/O from the Configurator
4-3-3

Parameter List

Operation Commands
and Status Bits for
the Temperature
Controllers
Allocated in IN Area Allocated in OUT Area
No Yes (See note 1.)
No Yes (See note 1.)
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
Yes No
Temperature
Controller Operation
Data and Parameters
50
A list of the data that can be allocated is shown here. The data is divided
broadly into operation commands and status bits for Temperature Controllers
and Temperature Controller operation data and parameters.
Note Some data can be allocated in the IN Area or the OUT Area only. The type
numbers are used to differentiate each item and are not used to actually spec-
ify settings.
The operation commands and status bits for the Temperature Controllers are
shown in the following table. This data is a collection of the Temperature Con-
troller flags and bits in the Communications Unit, and is not the variable area
of the directly corresponding Temperature Controllers.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Note 1. Always allocate the Output Enable Bits in the first two words of the OUT
Area.
2. Always allocate the Output Enable Bits Units 0 to 7 and Output Enable Bits
Units 8 to 15 in the first two words of the OUT Area.
The following table shows the data used to monitor operation, such as the
Temperature Controller's process values (PVs) and set points (SPs), the oper-
ation parameters such as PID constants, and initial setting parameters such
as input types. This data corresponds to the variable areas (C0, C1, and C3)
of the Temperature Controllers.
For details on how each of the data settings is used, refer to the E5ZN Tem-
perature Controller Operation Manual (H113).
Type number
Output Enable Bits Units 0 to 7
Output Enable Bits Units 8 to 15
E5ZN communications status
E5ZN communications error status
Alarm output 1 Units 0 to 7
Alarm output 1 Units 8 to 15
Alarm output 2 Units 0 to 7
Alarm output 2 Units 8 to 15
Alarm output 3 Units 0 to 7
Alarm output 3 Units 8 to 15
HB output Units 0 to 7
HB output Units 8 to 15
RUN/STOP Units 0 to 7
RUN/STOP Units 8 to 15
AT execute/cancel Units 0 to 7
AT execute/cancel Units 8 to 15
Auto/manual Units 0 to 7
Auto/manual Units 8 to 15
Setting area 0/1 Units 0 to 7
Setting area 0/1 Units 8 to 15
Software reset Units 0 to 7
Software reset Units 8 to 15
Unit status
Section 4-3
Item