Table of Contents
Advertisement
Operations from the Edit Device Parameters Window
2. A window for editing the unit parameters of the corresponding Temperature
Controller will be displayed.
Note a)
This icon indicates parameters that are shared by ch1 and
ch2. If a value for either ch1 or ch2 is changed, the other val-
ue will also change.
This icon indicates a parameter that is read only.
b) The Temperature Controller parameters are stored even if the
power is turned OFF.
3. Select the tab page of the channel for which the parameters are to be ed-
ited, and edit the parameters.
4. Click the parameter to be edited, and change the contents.
Note a) Click the Download Button to download the contents of Setting
Area 0/1. When this operation is performed, the Unit will be reset,
so do not use this operation while the Unit is in RUN mode.
Section 5-2
79
Advertisement
Chapters
Table of Contents
