Intel NetStructure MPCMM0001 Software Instructions page 87

Table 27. Dataitem Keywords for Cmm Location (Sheet 2 of 7)
dataitem
Retrieve or set the state of the
Telco Alarm cutoff. When
enabled, it silences the Telco
alarm for active events and
blinks the event LEDs on the
alarmcutoff
CMM. This dataitem is only
valid when used with the cmm
as the location and is used to
set the alarm cutoff or get its
value.
Retrieve or set the timeout
value in minutes for the Telco
Alarm cutoff. This is the
amount of time before the
alarm cutoff will automatically
become unset if the user
alarmtimeout
doesn't unset it themselves.
This dataitem is only valid
when used with the cmm as
the location and is used to set
the alarm timeout or get its
value.
Used only with the CMM
location to turn on or off the
criticalled
critical, major and minor leds.
minorled
When used with cmmset, a –v
majorled
value of 1 turns the LED on
while a 0 turns it off.
Included for backward
compatibility only.
Ethernet The mapping of the command
for existing dataitem is:
Ethernet = EthernetA
Used only with the CMM
location to change the eth0/
eth1 direction to either the
front panel, the rear panel IO
card, or backplane.
EthernetA
The mapping of the command
EthernetB
for existing dataitems are:
EthernetA = cmm1EthernetA
+ cmm2EthernetA
EthernetB = cmm1EthernetB
+ cmm2EthernetB
MPCMM0001 Chassis Management Module Software Technical Product Specification
Download from Www.Somanuals.com. All Manuals Search And Download.
Get/
Description
Set
Both
Both
Both
Both
Both
The Command Line Interface (CLI)
CLI Get Output
"Telco Alarm Cutoff is <enabled/
disabled>."
"Timeout is <timeoutvalue> minutes."
"1" if the LED is On
"0" if the LED is Off
"front" or "rear" or "backplane"
For example,
bash-2.04# cmmget -d ethernet
cmm1ethernetA: front
cmm2ethernetA: front
"Front" or "Rear" or "Backplane". For
example,
bash-2.04# cmmget -d ethernetA
cmm1ethernetA: front
cmm2ethernetA: front
bash-2.04# cmmget -d ethernetB
cmm1ethernetB: front
cmm2ethernetB: front
Valid Set Values
1 = Set cut off
0 = Unset cut off
Number of minutes:
0-1000.
Value of 0 disables
the time-out.
1 - Turn On LED
0 - Turn Off LED
"Front" – Set
direction to the front
panel.
"Back" – Set
direction to the rear
IO panel card.
"Front", "Rear", or
"Backplane"
87