Intel NetStructure MPCMM0001 Software Instructions page 176

Remote Procedure Calls (RPC)
Parameters
nAuthCode[in] Authentication code returned by GetAuthCapability().
uCmdCode[in] The command to be executed (CMD_GET or CMD _SET as defined in
pszLocation[in] The location that contains the data item that uCmdCode acts upon, such as system,
pszTarget[in] The target that contains the attribute that uCmdCode acts upon, such as the sensor
pszDataItem[in] The attribute that uCmdCode acts upon, either an attribute of pszLocation or
pszSetData[in] The new value to set. When not applicable, use "NA".
ppvbuffer[out] A pointer to the buffer containing the returned data.
uReturnType[out] The type of data that ppvbuffer points to (see the defines in cli_client.h).
The value definitions of the return codes may be found in
the RPC Interface" on page
Once the application has authenticated, it may proceed to get and set CMM parameters by calling
ChassisManagementApi(). For each call to ChassisManagementApi(), the calling application must
pass in the authentication code returned from GetAuthCapability(). The get and set commands
available through ChassisManagementApi() are the same as those available on the command-line
interface with cmmget and cmmset.
Note: SEL information is currently not available through the RPC interface.
176 MPCMM0001 Chassis Management Module Software Technical Product Specification
Download from Www.Somanuals.com. All Manuals Search And Download.
pszCMMHost [in] IP Address or DNS hostname of CMM.
cli_client.h).
CMM, or blade1.
name as listed in the Sensor Data Record (SDR). When not applicable,
use "NA" (such as when pszDataItem is an attribute of the pszLocation
rather than pszTarget.
pszTarget.
177.
Table 80, "Error and Return Codes for