Intel NetStructure MPCMM0001 Software Instructions page 177

Table 80. Error and Return Codes for the RPC Interface (Sheet 1 of 4)
Code #: Error Code String
0 E_SUCCESS
1 E_BPM_BLADE_NOT_PRESENT
2
E_ECMM_SVR_COMMAND_UNSUPPORTED
3 E_CLI_MSG_SND
4 E_CLI_INVALID_TARGET
5 E_CLI_INVALID_LOCATION
6 E_CLI_INVALID_DATA_ITEM
7 E_CLI_INVALID_SET_DATA
8 E_CLI_INVALID_REQUEST
9 E_CLI_MSG_RCV
10 E_CLI_NO_MORE_DATA
11 E_CLI_DATA_TYPE_UNSUPPORTED
12 E_ECMM_CLIENT_CONNECT_ERROR
13 E_ECMM_SVR_AUTH_CODE_FAIL
14
E_CLI_STANDBY_CMM
15
E_WP_INITIALIZING
16 E_BPM_NON_IPMI_BLADE
17
E_BPM_STANDBY_CMM
18
E_BPM_NO_MORE_DATA
19 E_BPM_INVALID_SET_DATA
20 E_CLI_INVALID_BUFFER
21 E_CLI_INVALID_CMM_SLOT
22 E_CLI_NO_MSGQ_KEY
23 E_CLI_NO_MSGQ
24 E_CLI_NO_MSGQ_LOCK
25 E_CLI_NO_MSGQ_UNLOCK
26 E_CLI_FILE_OPEN_ERROR
27 E_CLI_CFG_WRITE_ERROR
28 E_IMB_NO_MSGQ
29 E_IMB_NO_MSGQ_KEY
30 E_IMB_SEND_TIMEOUT
31 E_IMB_DRIVER_FAILURE
32 E_IMB_REQ_TIMEOUT
33 E_IMB_RECEIVE_TIMEOUT
MPCMM0001 Chassis Management Module Software Technical Product Specification
Download from Www.Somanuals.com. All Manuals Search And Download.
Remote Procedure Calls (RPC)
Error Code Description
Success
Blade isn't in the chassis.
ECMM_SVR: Unsupported Command
Error.
CLI Send Message Error.
Not a valid -t parameter.
Not a valid -l location.
Not a valid -d parameter.
Not a valid -v parameter.
CLI Invalid Request Error.
CLI Receive Message Error.
No data found to retrieve.
CLI Data Type Unsupported.
ECMM_CLIENT: RPC Connect Error.
Invalid auth code passed to RPC interface.
Operation cannot be performed on standby
CMM.
The CMM is Initializing and Not Ready.
Wait a few seconds and try again.
Blade does not support IPMI.
BPM operation cannot be performed on
standby CMM.
Couldn't delete a board from the drone
mode list.
Not a valid -v parameter.
Internal CMM Error
Internal CMM Error
Internal CMM Error
Internal CMM Error
Internal CMM Error
Internal CMM Error
Internal CMM Error
CMM Config File Error.
Internal CMM Error
Internal CMM Error
Internal CMM Error
Internal CMM Error
A blade is not responding to IPMI requests.
A blade is not responding to IPMI requests.
177