Intel NetStructure MPCMM0001 Software Instructions page 146

SNMP
Table 63. Cmm Location (1.3.6.1.4.1.343.2.14.2.10.3) (Sheet 1 of 3)
OID
1 softwareVersion
2 cmmRedundancy
3 rmcpEnabled
4 cmmGrantedBoardEkeys
5 cmmTotalFrus
6 cmmPICMGProperties
7 cmmDeviceID
8 cmmPresence
9 cmmListTargets
10 cmmListDataItems
11 cmmHealth
12 cmmHealthEvents
13 cmmSNMPEnable
14 -
CmmSNMPTrapAddressN
18
19 cmmSNMPTrapCommunity
20 cmmSNMPTrapVersion
21 cmmSNMPTrapPort
22 cmmFaultLEDColor
23 cmmAlarmCutoff
146 MPCMM0001 Chassis Management Module Software Technical Product Specification
Download from Www.Somanuals.com. All Manuals Search And Download.
Object Syntax
DisplayString read-only
DisplayString read-only
INTEGER
DisplayString read-only
DisplayString read-only
DisplayString read-only
DisplayString read-only
INTEGER
DisplayString read-only
DisplayString read-only
INTEGER
DisplayString read-only
INTEGER
IP Address
DisplayString read-write
DisplayString read-write
DisplayString read-write
DisplayString read-write
INTEGER
Access Value
The version of the CMM software.
cmm redundancy information.
Enable or disable the RMCP Service:
read-write
disable(0), enable(1)
Get the Ekeys that have been granted
to the location.
display the total number of FRUs.
Used to find out if a location is present
read-only in the chassis.1 - Present 0 - Not
present
Used to find out what targets are
available on a location (e.g., getting the
list of sensors in the chassis).
Used to find out what data items are
available on a target or location.
Health information about a particular
location. This will be one of the
read-only
following: (0-OK, 1-Minor, 2-Major, 3-
Critical)
Events that contribute to the health of
the location. This is a list of events
happening on the location.
Used to set or query SNMP trap
read-write
enabled status.
The IP address of the machine that will
read-write
receive SNMP traps from a location.
SNMP community name (max 64
characters).
v1 or v3
SNMP trap port.
Get/Set the color of the fault/health LED
on the CMM fronted FRUsto be used
when an error is reported. Values:
"amber" or "red".
The Telco Alarm cutoff. When enabled,
it silences the Telco alarm for active
events and blinks the event LEDs on
read-write the CMM. This dataitem is only valid
when used with the cmm as the location
and is used to set the alarm cutoff or
get its value. 1 - Set, 0 - Clear.