Master Header/Terminator ( Prefix/Suffix); Rs-485 Cradle Address - Datalogic PowerScan PD9530 Product Reference Manual

RS-485 Master Header/Terminator ( Prefix/Suffix)
Specifies the Master Cradle header or terminator characters to be added to a
label sent to Host. The characters may be added as a prefix (in a position
before the bar code data, also called a header) and/or as a suffix (in a posi-
tion following the bar code data, also called a terminator).
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the "Set Master
Cradle Prefix" or "Set Master Cradle Suffix" bar code followed by the digits
(in hex) from the Alphanumeric characters in
senting your desired character(s). If less than the expected string of 8 char-
acters are selected, scan the ENTER/EXIT bar code to terminate the string.
Exit programming mode by scanning the ENTER/EXIT bar code again.
$CR4A1
Set Master Cradle Suffix
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

RS-485 Cradle Address

Specifies the Address for the Cradle in the RS-485 network.
$CS1AD
Set Cradle Address
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
Enter/Exit Programming Mode
Appendix D, Keypad
$CR4A0
Set Master Cradle Prefix
~
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
CANCEL
repre-
.
representing your
243