Reception Warning Message; Master Header/Terminator Selection; Data Format; Header/Terminator Selection - Datalogic PowerScan D8300 Reference Manual

®
POWERSCAN D8330/M8300/M8300-DK
The message is sent in the following format:
5.3.3

Reception Warning Message

The Master cradle can transmit warning messages to the Host regarding wrong
reception of data. Example:
/*Two-Ways Out of Sequence!(.....)*/
This message is transmitted to the Host by the Master cradle when the
Master cradle receives a closing string from the Host for a Two-way tx
communication, but this was either not open or already closed, therefore the
data will be lost. See par. 5.9.4.
5.3.4

Master Header/Terminator Selection

In addition to the standard header/terminator selection, the Master cradle can add its
own header/terminator to the entire message sent to the Host.
In the STAR-System™ network headers and terminators for all RF Devices are
disabled by default.
The Master header and terminator default values are as follows depending on the
interface selection towards the Host:
RS-232:
WEDGE:
See par. 5.4.1 and
5.4

DATA FORMAT

For an overview of Message Formatting see Chapter 6.
5.4.1

Header/Terminator Selection

The header/terminator selection is not effected by the reading of the restore default
code. In fact, header and terminator default values depend on the interface selection:
RS-232:
WEDGE:
166
"Message" CR LF
no header, terminator CR-LF
no header, terminator ENTER
.
5.4.2
no header, terminator CR-LF
no header, terminator ENTER