Batch Features; Batch Mode; Send Batch - Datalogic PowerScan 9500 Series Product Reference Manual

Batch Mode

This option specifies whether to store labels in the handheld while discon-
nected from the base. Options are as follows:
•
•
•
DEFAULT
$CBTBM01(CR)
Batch Mode = Automatic

Send Batch

When the scanner is configured in Manual Batch Mode, use the following bar
code to initiate sending of labels stored in batch memory.
Product Reference Guide

BATCH FEATURES

Disabled — The handheld will not store/batch labels.
Automatic — The handheld will store labels to RAM when the handheld
goes out of range and is disconnected from the remote device.
Manual — The handheld will always store labels to Flash memory. The
user must manually send the stored labels to the remote device using a
special "batch send" label.
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunc-
tion with this bar code.
BatchSend
Enter/Exit Programming Mode
$CBTBM00(CR)
Batch Mode = Disabled
$CBTBM02(CR)
Batch Mode = Manual
Send Batch
215