Table of Contents
Advertisement
2.4.2 Dynamic Aggregation Configuration
Dynamic aggregation differs from static aggregation in that port quantity is fixed in static
aggregation, but quantity of actually aggregated port is adjusted dynamically according to flow
rate strategy.
Step 1
Add the ports to the dynamic group.
1)
Select LACP (Active) in the Mode area, and add the ports to the aggregation
group. For example, add port 3 and port 4 to aggregation group 2. See Figure 2-6.
2)
Select LACP (Passive) in the Mode area, and add the ports to the aggregation
group. For example, add port 5 and port 6 to aggregation group 3. See Figure 2-6.
Step 2
Click OK.
2.5
IP and Route
You can add the IP address of VLAN virtual interface and IP route. For details, see "3.1.1.2 IP
and Route."
Step 1
Click IP & Route on the Quick Setting interface.
The IP & Route interface is displayed. See Figure 2-7.
Figure 2-6
Dynamic configuration
Quick Settings 6
Advertisement
Table of Contents
