Table of Contents
Advertisement
1-4
IFNAME
Default
None
Command Mode
Global configuration mode
Example
//This command is to configure the session 1 source port for G1,G2, destination
port for G3.
switch(config)# monitor session 1 both destination G3 source G1
G2
3.4
Link aggregation
Static aggregation configuration commands include:
Trunk
Dynamic aggregation configuration commands include:
lacp enable | disable
lacp active | passive
lacp key
lacp port-priority
Function Brief
Link aggregation is used to form a logical port using multiple physical
ports of a switch. Multiple links within the same aggregation group are
deemed as a larger bandwidth logical link.
By link aggregation, the communication traffic is shared among
member ports of the aggregation group, and thus the bandwidth is increased.
Besides, member ports of the same aggregation share dynamic backups
with each other, and thus the link reliability is improved.
Member ports of the same aggregation group shall have the same
configurations. The configurations mainly include STP, QoS, VLAN, port
attribute, MAC address learning, ERPS configuration, loop protection
configuration, mirror, 802.1x, IP filtering, MAC filtering, port isolation, etc.
3.4.1
trunk
Command Description
Port mirror number
port number,Example G1,T1
Hide quick links:
Advertisement
Table of Contents
