Table of Contents
Advertisement
Parameter
Flow Control
Speed/Duplex
VLAN
POE
Receive Usage
Send Usage
Media Type
2.2
Local
You can set the system name, IP address, and subnet mask.
Step 1
Click Local on the right of Quick setting interface.
The Local interface is displayed. See Figure 2-2.
Step 2
Enter the system name, IP address, and mask length.
Step 3
Click OK.
2.3
VLAN
Add the port to the VLAN, and configure the VLAN. By default, the port is VLAN1.
Step 1
Click Vlan on the Quick Setting interface.
The Vlan interface is displayed. See Figure 2-3.
Description
Displays the flow control state.
Online: It displays the port rate and the duplex mode.
Offline: It displays Down.
VLAN port. It is VLAN 1 by default.
Displays the power consumption of POE. Only 1–4 ports are PoE ports.
The current receiving speed is divided by the average speed in a
certain period (5 minutes usually).
The current sending speed is divided by the average speed in a certain
period (5 minutes usually).
Two media types: Copper and Fiber. Copper indicates RJ-45 port,
and Fiber indicates fiber port.
Figure 2-2
Local
Quick Settings 3
Advertisement
Table of Contents
