Table of Contents
Advertisement
Step 2
Select the aggregation load balancing algorithm mode in Aggregation Configuration.
There are four types:
Source MAC Address: The aggregation load balancing algorithm based on MAC
address.
Destination MAC Address: The aggregation load balancing algorithm based on
destination MAC address.
IP Address: The aggregation load balancing algorithm based on source IPv4
address and destination IPv4 address.
TCP/UDP Port: The aggregation load balancing algorithm based on source and
destination TCP/UDP port.
Step 3
Select Static in the Mode area, and add the ports to the dynamic aggregation group.
For example, add port 1 and port 2 to aggregation group. See Figure 3-11.
Regarding 4-port PoE switch, at most 3 static aggregation groups can be set at the
same time. The static aggregation group is different depending on the models of switch.
The actual interface shall prevail.
Step 4
Click Save.
The port 1 and port 2 form a logical port.
3.1.4.2 LACP
LACP (Link Aggregation Control Protocol) is the protocol for link dynamic aggregation. LACP
communicates with another port through LACPDU (Link Aggregation Control Protocol Data
Unit).
Select the port role from the drop-down list in Mode. There are two types:
Active: The port can send LACPDU packet actively to the opposite port, and analyzes the
LACP.
Passive: The port cannot send LACPDU packet actively. After receiving the LACP packet
sent by the opposite port, the port analyzes the LACP.
Step 1
Select Advanced > Common > Aggregation.
The Aggregation interface is displayed. See Figure 3-12.
Figure 3-11
Static configuration
Advanced Settings 19
Advertisement
Table of Contents
