Vlan Configuration - Dahua DH-PFS4218-16GT2GF-240 Manual

Parameter
Ingress Limit (kbps)
Egress Limit Enable
Egress Limit (kbps)
Receive Usage
Send Usage
Step 3 Click Save.

3.1.3 VLAN Configuration

Add the port to the VLAN, and configure the VLAN. By default, the port belongs to VLAN1.
Step 1 Select Advanced > Common > VLAN Settings.
The VLAN Settings interface is displayed. See Figure 3-9.
Step 2
Enter 1, 2 in VLANs to create VLAN 1 and VLAN 2.
Step 3 Configure the port VLAN parameters. See Table 3-4.
Parameter
Port
Mode
Description
Set the ingress limit.
Enable/Disable egress limit.
 : Egress enable is enabled.
 : Egress enable is disabled.
Set the egress limit.
Displays the acceptance usage.
Displays the send usage.
Figure 3-9 VLAN Settings
Table 3-4 Port VLAN configuration parameter
Description
Displays all ports of the switch.
Three modes: Access, Hybrid, and Trunk.
Advanced Settings 17