The layer 2 device added into ERPS are called node. Add no more than 2 ports into an ERPS
for each node.
Step 1
Select Advanced > Seldom-used > ERPS > MEP Setting.
The MEP Setting interface is displayed. See Figure 3-25.
Step 2
Click Add.
The Add interface is displayed. See Figure 3-26.
Step 3
For the parameters, see Table 3-5.
Parameter
Instance
Residence Port
Level
Tagged VID
Step 4
Click OK.
3.2.1.2 ERPS Configuration
Step 1
Select Advanced > Seldom-used > ERPS > ERPS Settings.
The ERPS Settings interface is displayed. See Figure 3-27.
Figure 3-25
MEP configuration
Figure 3-26
Add
Table 3-5 MEP parameters
Description
Enter MEP instance number, such as 1.
Enter the port number that MEP belongs to, such as Port 1.
Maintenance level. It is recommended to set it to be 0.
Enter protocol VLAN, such as VLAN 3.
Advanced Settings 29