Step 3
In Port Configuration, select Source or Destination according to the actual situation.
Select the following four ways for source port.
Both: Enable the port as the source address of mirror.
Disable: Disable the port as the source address of mirror.
Rx only: The port only mirrors receiving data, rather than sending data.
Tx only: The port only mirrors sending data, rather than receiving data.
Select the Destination box to set the port to be destination.
Step 4
Click Save.
4.6
Ping
With Ping protocol, you can check whether the device with a specified IP address can be
accessed, and check whether the network connection fails.
Step 1
Select Maintain > Common > Ping.
The Ping interface is displayed. See Figure 4-7.
Step 2
Enter the IP address, and click Ping.
4.7
Functions of Network Management System
4.7.1 Enabling Function and Logging in to Platform
The functions of network management system is to support iLinksView network management
platform. You can enable or disable the network management function and change the
username and password.
The username and password must be the same as those of ILinksView network management
platform.
Figure 4-7
Ping
Maintenance 72