You can view the system information, and set the device parameters, VLAN, link aggregation,
IP address and route. Take 4-port PoE switch for example. The quick setting interface is
different depending on the models of switch. The actual interface shall prevail.
2.1
System Information
You can view the name, type, serial number, software version, IP address, port status and port
information of the device.
After logging in the system, the Quick Setting interface is displayed. See Figure 2-1. On the
switch, if the port shows green, it means the port is connected successfully. And If the port
shows gray, it means the port is not connected or the connection fails. See Table 2-1.
Parameter
Port
Port Type
Link
2
Quick Settings
Figure 2-1
System information
Table 2-1 Port information
Description
Displays all ports of the switch.
This switch contains 7 ports. Port quantity might vary depending on the
model you purchased, and the actual product shall prevail.
Three types: Access, Hybrid, and Trunk.
Two link states: Up and Down. Up indicates the port is connected
successfully, and Down indicates the port is not connected or the
connection fails.
Quick Settings 2