Adding Through Ap Configuration - Dahua DHI-ARA3000H-FW2 User Manual

Step 2 Tap
Step 3 Tap
Scan device QR code, or tap Manually Add to manually enter device SN.
Step 4
Step 5 Select a site, and then tap OK.
On the Add Device screen, select a device type.
Step 6
Step 7 Connect to wireless or wired network.
● Wireless
1) Tap Wireless on the upper-right corner, and then Wireless becomes Wired.
2) Enter the password for the Wi-Fi that your phone is connected to, and then tap
Connect.
3) Follow the on-screen instructions, and then tap Next.
4) Wait for the pairing.
If failed, repeat the above procedures.
● Wired
1) Tap Wired on the upper-right corner, and then Wired becomes Wireless.
2) Connect the device to power and the network, and then tap Next.
If failed, repeat the above procedures.
Step 8 If the hub you are adding is uninitialized, enter password and confirm it again, and then
tap Initialize the device to complete initialization.
Step 9 Tap Completed, and then you can view the device in the device list.

4.2.1.2 Adding through AP Configuration

You can add the hub through AP configuration.
Step 1 On the Home screen, tap
Step 2 Tap
Step 3 Tap
Figure 4-2 Add a device
on the upper-left corner to switch to Device mode.
to add a device.
, and then it goes to Sites screen.
on the upper-left corner to switch to Device mode.
to add a device.
15
User's Manual