Table of Contents
Advertisement
The ERPS VLAN Configuration interface is displayed.
2)
Click Add.
3)
Set ERPS VLAN to be 2. See Figure 3-36.
4)
Click OK.
5)
Set port 2 of switch 1 to be RPL owner in RPL Configuration. See Figure 3-37.
Step 7
Click OK.
Step 8
Configure switch 2 and switch 3 in the same way.
Step 9
View the state in Instance State on the ERPS Configuration interface.
3.2.2 ACL
ACL (Access Control List) is for flow identification. For filtering the packet, the network device
needs to configure a series of matching conditions to classify the packets. The conditions can
be the source address, destination address, and the port number of the packet.
Figure 3-36
ERPS VLAN configuration
Figure 3-37
Owner port configuration
Figure 3-38
Instance state
Advanced Settings 36
Advertisement
Table of Contents
