Dynamic Aggregation Configuration; Ip And Route - Dahua DH-PFS4212-8GT-96 Web Operation Manual

2.4.2 Dynamic Aggregation Configuration

Dynamic aggregation differs from static aggregation in that port quantity is fixed in static
aggregation, but quantity of actually aggregated port is adjusted dynamically according to flow rate
strategy.
Step 1 Add the ports to the dynamic group.
1) Select LACP (Active) in the Mode area, and add the ports to the aggregation group.
For example, add port 3 and port 4 to aggregation group 2.
2) Select LACP (Passive) in the Mode area, and add the ports to the aggregation group.
For example, add port 5 and port 6 to aggregation group 3.
Step 2 Click OK.
2.5

IP and Route

You can add the IP address of VLAN virtual interface and IP route. For details, see "3.1.1.2 IP and
Route."
Click IP & Route on the Quick Setting interface.
Step 1
The IP & Route interface is displayed.
Figure 2-6 Dynamic configuration
6