Switching Fabric Modules; Sfe-L1 - H3C SR6604 Manual

Power button
WARNING!
The device might still have power after you press the power button. Do not reboot the RPE-X5E
MPU or remove power cords from the RPE-X5E MPU until the power button/LED goes off.
CAUTION:
• Forced power-off might cause data loss in virtual machines. Please use it with caution.
• Avoid accidentally pressing the power button when the device is operating. Doing so will power
off the device system and cause service interruption.
• If a virtual machine cannot be shut down gracefully, log in to it, terminate the running processes,
and then shut down it.
The power button is used to power on or power off the Comware system and virtual machines
created on the Comware system.
To gracefully shut down the Comware system when the device is operating, press and hold the
power button for 0.5 to 3 seconds. To forcibly shut down the Comware system, press and hold the
power button for more than 3 seconds.
By default, pressing the power button on a powered-off device starts the Comware system but not
the virtual machines. You can use the autostart command to configure the virtual machines to be
started together with the Comware system.
Typically, you can use the reboot command to reboot the RPE-X5E MPU. However, if the RPE-X5E
MPU is powered off by pressing the power button, you need to press the power button to turn it on
and then execute the reboot command.

Switching fabric modules

The SR6600 router supports switching fabric modules only when it is installed with RPE-X3, RPE-X5,
or RPE-X5E MPUs.

SFE-L1

Front panel
Figure2-8 SFE-L1 front panel
1 2
(1) Captive screw
(3) Switching fabric module status LED (RUN)
Technical specifications
Table2-14 SFE-L1 specifications
Item
Memory type and size
(2) Ejector lever
Specification
DDR2 SDRAM
2-11
3