H3C SR6604 Manual page 68

LED
Figure3-6 MCP-X1 LEDs
1
Table3-7 MCP-X1 LED description
LED
GE0 through
1
GE3
(yellow/green)
CF
2
(yellow/green)
3
RUN
(green)
4
ACT
(green)
5
PALM
(red)
6 ALM
Status
8
Status
Off
Steady green
Flashing green
Steady yellow
Flashing yellow
Off
Steady green
Flashing green
Steady yellow
Off
Slow flashing (1
Hz)
Fast flashing (8
Hz)
Off
Steady on
Off
Steady on
Off
3-9
Description
is insufficient. In this state, check the system log
immediately.
2
7 7
Description
The corresponding interface is not connected.
A 1000 Mbps link is present.
Data is being received or transmitted at 1000
Mbps.
A 10/100 Mbps link is present.
Data is being received or transmitted at 10/100
Mbps.
No CF card is present or the CF card is not
recognizable.
A CF card is in position and has been detected.
The system is accessing the CF card. In this
state, do not remove the CF card.
A CF card not provided by H3C.
No power input is available, or the MCP-X1 has
failed.
The MCP-X1 is operating correctly.
The application software is being loaded (in this
case, never power off the device or hot-swap the
MCP-X1; otherwise the MCP-X1 might be
damaged).
The MCP-X1 is in standby state.
The MCP-X1 is in active state.
The system power module is normal.
The system power is insufficient.
The system is operating correctly and no alarm
has occurred.
3
4
5
５
6