H3C SR6604 Manual page 31

fiber command in interface view. For more information about the combo enable
}
command, see H3C SR6600/SR6600-X Routers Interface Command Reference(V7).
A FIP is a processing engine and you can install different interface modules in a FIP to support
different network services as needed. This section describes the FIP modules available for the H3C
SR6604 and SR6608 routers.
When you order or install a FIP, use
FIP-10
The FIP-10 supports only MIMs, and you can plug at most four MIMs into a FIP.
Front panel
Figure2-10 FIP-10 front panel
(1) Slot 4
(3) OPEN BOOK mark
(5) Slot 1
The OPEN BOOK mark indicates that the operator must read the following document before working
with the FIP:
Table2-16 References for FIP operations
Operation
Install and remove the FIP
Install and remove MIMs
Connect network cables
Connect optical fibers
Technical specifications
Item
HIM
MIM
MIC
Hot-swapping
Slot
Table2-38
1
6
Reference
H3C SR6604[6608] Routers Installation Guide
Specification
Not supported
4 MIMs supported at the same time
Not supported.
Supported
Four
2-13
to check the FIP and MPU compatibility.
2
5
(2) Slot 3
(4) Status LED (RUN)
(6) Slot 2
copper fiber
{ |
4 3
}