Installing Switching Fabric Modules - H3C CR16000-M Installation Manual
Hide thumbs
Also See for CR16000-M:
- Installation, quick start (4 pages) ,
- Quick start manual (21 pages)
Table of Contents
Advertisement
Figure4-3 Installing an MPU
Installing switching fabric modules
1.
Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.
For more information, see
2.
Remove the filler panel (if any) from the target switching fabric module slot.
Keep the filler panel secure for future use.
Figure4-4 Remove the filler panel from the target switching fabric module slot
3.
As shown by callout 1 in Figure4-5, press the ejector buttons of the two ejector levers
simultaneously to release the ejector levels.
"Attaching an ESD wrist
4-3
strap."
Advertisement
Chapters
Table of Contents
