H3C SR6604 Manual page 70

LED
3
RUN
(green)
4
ACT
(green)
5
PALM
(red)
6
ALM
(red)
LINK
7
ACT
SFP+LINK/ACT
8
SFP0 through
SFP3
9
(yellow/green)
Status Description
No power input is available, or the MCP-X1 has
Off
failed.
Slow flashing
The MCP-X1 is operating correctly.
(1 Hz)
The application software is being loaded (in this
Fast flashing case, never power off the device or hot-swap the
(8 Hz) MCP-X1; otherwise the MCP-X1 might be
damaged).
Off The MCP-X1 is in standby state.
Steady on The MCP-X1 is in active state.
Off The power system is operating correctly.
Steady on The system power is insufficient.
The system is operating correctly and no alarm has
Off
occurred.
A fault has occurred on the system or the available
Steady on power is insufficient. In this state, check the system
log immediately.
Off The corresponding interface is not connected.
Steady green A 1000 Mbps link is present.
Steady yellow A 10/100 Mbps link is present.
Off No data is being received or transmitted.
Flashing
Data is being received or transmitted.
yellow
Off No link is present.
Steady green A 10 Gbps link is present.
Flashing green Data is being received or transmitted at 10 Gbps.
Steady yellow Transceiver module check has failed.
Off No link is present.
Steady green A 1000 Mbps link is present.
Data is being received or transmitted at 1000
Flashing green
Mbps.
Steady yellow A 100 Mbps link is present.
Flashing
Data is being received or transmitted at 100 Mbps.
yellow
3-11