H3C SR6604 Manual page 65

LED
NT
(yellow/green)
5
ALM
(red)
6
ACT
(green)
Figure3-4 LEDs on the RPE-X5E
1
8 7
Table3-5 RPE-X5E LED description
LED
1
RUN
(yellow/green)
Status
Flashing green
Steady yellow
Flashing yellow
Off
Fast flashing (10
seconds)
Steady on
Off
Steady on
Off
2 3
6
Status
Fast flashing
green
Slow flashing
yellow
Fast flashing
yellow
Off
Steady green
Fast flashing
green
Slow flashing
green
Steady yellow
Slow flashing
yellow
Off
3-6
Description
Data is being received or transmitted at 1000 Mbps.
A 100 Mbps link is present.
Data is being received or transmitted at 100 Mbps.
No link is present or the port is faulty.
USB-based automatic configuration has failed.
A fault has occurred on the system.
The system is operating correctly and no alarm has
occurred.
The MPU is in active state.
The MPU is in standby state.
4
5
Description
The BIOS is operating correctly.
No or insufficient memory or
initialization failure.
BIOS stage
The extended segment does not exist.
Hardware failure or no power input.
The SDRAM is performing self-test.
The BootWare runs.
The Comware system has started with
the configuration file and the system is
BootWare
operating correctly.
stage
The boot image does not exist.
The SDRAM has failed the self-test.
Hardware failure or no power input.