H3C SR6604 Manual page 64

Figure3-3 LEDs on the RPE-X5
1
6
Table3-4 RPE-X5 LED description
LED
1
RUN
(yellow/green)
2
PALM
(red)
3
IRF
(yellow/green)
MANAGEME
4
3
2
5
Status
Fast flashing
green
Slow flashing
yellow
Fast flashing
yellow
Off
Steady green
Fast flashing
green
Slow flashing
green
Steady yellow
Slow flashing
yellow
Off
Slow flashing
green
Fast flashing
green (5
seconds)
Steady on
Off
Slow flashing
green
Steady green
Steady yellow
Off
Steady green
3-5
4
Description
The BIOS is operating correctly.
No or insufficient memory or initialization
failure.
BIOS stage
The extended segment does not exist.
Hardware failure or no power input.
The SDRAM is performing self-test.
The BootWare runs.
The Comware system has started with
the configuration file and the system is
BootWare
operating correctly.
stage
The boot image does not exist.
The SDRAM has failed the self-test.
Hardware failure or no power input.
The system is operating correctly.
Comware
stage
USB-based automatic configuration has
succeeded.
The system power is insufficient.
The power system is operating correctly.
The device is in IRF mode and the MPU is the global
active MPU.
The device is in IRF mode and the MPU is a standby
MPU.
The device is in IRF mode but the IRF configuration
has failed.
The device is in standalone mode.
A 1000 Mbps link is present.