H3C SR6604 Manual page 67

LED
Figure3-5 RSE-X1 LEDs
Table3-6 RSE-X1 LED description
LED
1
CF
(green)
USB
2
(green)
LINK/ACT
3
(yellow/green)
4
ACT
(green)
5
PALM
(red)
6
RUN
(green)
7
ALM
(red)
Status Description
Steady red The shutdown of the Comware system is in progress.
Off The Comware system has shut down.
1
Status Description
Off No CF card is present or the CF card is not recognizable.
Steady on A CF card is in position and has been detected.
The system is accessing the CF card. In this state, do not
Flashing
remove the CF card.
Off No host is connected to the device-mode USB port.
A host is connected to the device-mode USB port. The
Steady on
USB cable can be unplugged in this state.
Data is being transmitted or received through the
Flashing device-mode USB port. In this state, do not unplug the
USB cable.
Steady yellow A 10/100 Mbps link is present.
Steady green A 1000 Mbps link is present.
Flashing
Data is being received or transmitted at 10/100 Mbps.
yellow
Flashing green Data is being received or transmitted at 1000 Mbps.
Off The RSE-X1 is in standby state.
Steady on The RSE-X1 is in active state.
Off The system power module is normal.
Steady on The system power is insufficient.
Off No power input is available, or the RSE-X1 has failed.
Slow flashing
The RSE-X1 is operating correctly.
(1 Hz)
The application software is being loaded (in this case,
Fast flashing
never power off the device or hot-swap the RSE-X1;
(8 Hz)
otherwise the RSE-X1 might be damaged).
The system is operating correctly and no alarm has
Off
occurred.
Steady on
A fault has occurred on the system or the available power
3-8
2 3 4 6
5 7