H3C SR6604 Manual page 38

Item
Combo interface
HIM
MIM
MIC
Hardware encryption
Hot swapping
Combo interface specifications
Specifications of combo interfaces on the FIP-300 and the FIP-110 are the same. For more
information, see
FIP-310
The FIP-310 provides four combo interfaces and two SFP+ ports. It supports HIMs, MIMs, or a mix of
HIMs and MIMs.
Front panel
Figure2-17 FIP-310 front panel
13 12
(1) Combo interface 1
(4) SFP+ port 0
(7) SFP+ port 1 status LED
(10) Combo interface 0
(13) Captive screw
Technical specifications
Item
Flash
Memory type and size
Specification
12
Copper ports (MDI/MDIX
autosensing)
Fiber ports
1
1
Not supported
Supported
Supported
Table2-19 and Table2-20.
11
(2) Combo interface status LED
(5) SFP+ port 1
(8) SFP+ port 0 status LED
(11) HIM/MIM slot
Specification
8 MB
•
Default—Two 2-GB DDR3 SDRAMs
•
Maximum—Two 2-GB DDR3 SDRAMs
The SDRAMs must be used in pairs and must be the same size.
They must be inserted in slot 1 or slot 3. These two slots are located near
the backplane connectors on the FIP module.
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
2 3
1
10 9
2-20
4 5
6
8 7
(3) Combo interface 3
(6) RUN LED
(9) Combo interface 2
(12) Ejector lever