Slot Arrangement For Mpus, Switching Fabric Modules, And Service Modules; Numbering Interfaces - H3C SR6604 Manual

Slot arrangement for MPUs, switching fabric
modules, and service modules
Table4-1 Slot arrangement for MPUs, switching fabric modules, and service modules
MPUs, switching fabric
modules, and service
modules
MPUs
RPE-X1/RPE-X3/RPE-X5/
RPE-X5E (supporting 1+1
redundancy)
RSE-X1 (supporting 1+1
redundancy)
MCP-X1/X2 (supporting
1+1 redundancy)
Switching fabric modules
SFE-L1
SFE-L2
Service modules
FIP-10
FIP-20
FIP-110
FIP-210
FIP-240
FIP-260
FIP-300
FIP-310
FIP-380
FIP-600
FIP-660
FIP-680
SAP/OAP card

Numbering interfaces

Before installing a HIM/MIM/MIC/MIC-X, you must install a FIP.
The interfaces of the router are numbered in the form of interface-type X/Y/Z,
Slot arrangement on the
SR6604
Slot 0 and slot 1
An SR6608-DS router does not support the RPE-X1 MPU.
Slot 1 and slot 2
Not supported on an SR6608-DS router.
Slot 1 and slot 2
Not supported on an SR6608-DS router.
Slot 2 and slot 3
N/A
Slot 2 and slot 3
4-3
Slot arrangement on the
SR6608
Slot 2 through slot 5
Not supported on an SR6608-DS
router.
Slot 2 and slot 3 on an SR6608-DS
router. (To install the SFE-L2
switching fabric module in slot 3 on an
SR6608-DS router, first install a
carrier in the slot.)
•
Slot 2 through slot 5
(The router does not support
installing the FIP-240 or FIP-680
in slot 5 if it is installed with the
RPE-X5 or RPE-X5E MPU.)
•
Slot 3 through slot 5 on an
SR6608-DS router
(The SR6616-DS router does not
support the FIP-240 and does
not support installing the FIP-680
in slot 5 if it is installed with the
RPE-X5 or RPE-X5E MPU.).