Mpu Leds - H3C SR6604 Manual

MPU LEDs

CAUTION:
To avoid damaging the file system on the CF card, do not remove the CF card when the CF LED is
flashing.
Figure3-1 LEDs on the RPE-X1
Table3-2 RPE-X1 LED description
LED
1
(green)
2
(green)
3
(red)
4
(yellow/green)
5
(green)
1
2 4
3
Status
Off
Slow flashing (1
Hz)
RUN
Fast flashing (8
Hz)
Off
ACT
Steady on
Off
ALM Steady on
Fast flashing (8
Hz)
Steady yellow
Steady green
LINK/ACT
Flashing yellow
Flashing green
Off
CF Steady on
Flashing
USB Off
5
6
Description
No power input is available, or the RPE-X1 has failed.
The RPE-X1 is operating correctly.
The application software is being loaded (in this case,
never power off the device or hot-swap the RPE-X1;
otherwise the RPE-X1 might be damaged).
The RPE-X1 is in standby state.
The RPE-X1 is in active state.
The system is operating correctly and no alarm has
occurred.
A fault has occurred on the system or the available
power is insufficient. In this state, check the system log
immediately.
A critical fault has occurred to the system. In this state,
handle the fault immediately.
A 10/100 Mbps link is present.
A 1000 Mbps link is present.
Data is being received or transmitted at 10/100 Mbps.
Data is being received or transmitted at 1000 Mbps.
No CF card is present or the CF card is not
recognizable.
A CF card is in position and has been detected.
The system is accessing the CF card. In this state, do
not remove the CF card.
No host is connected to the device-mode USB port.
3-3