Automation - Yamaha DM2000 Owner's Manual

250
Chapter 19—Pro Tools Remote Layer

Automation

Viewing the Automation Mode
The Automation mode setting of each channel can be viewed as follows.
Press and hold a channel's [AUTO] button.
1
The channel's Automation mode is displayed on the corresponding channel strip display
while the [AUTO] button is pressed.
Auto write
Auto touch
Auto latch
Auto read
Auto off
The Automation mode settings of all channels can be viewed as follows.
2 Press and hold the AUTOMIX [DISPLAY] (AUTO STATUS) button.
The Automation modes of all channels are displayed on the channel strip displays while the
AUTOMIX [DISPLAY] (AUTO STATUS) button is pressed.
Setting the Automation Mode
The Automation mode can be set as follows.
While holding down a channel's [AUTO] button, press the AUTOMIX
1
[WRITE], [TOUCH], [LATCH], [TRIM], [READ], or [OFF] button.
The channel's Automation mode is displayed on the corresponding channel strip display
while the [AUTO] button is pressed.
Grouped channels are set together. You can temporarily disable a group in order to set indi-
vidual channels by pressing and holding the USER DEFINED KEYS [12] (CTRL/CLUTCH)
button.
The following shortcuts apply.
Set the Automation mode of all channels
Set the Automation mode of all selected
channels
DM2000 Version 2—Owner's Manual
Pro Tools Channel Strip Displays
To do this...
Wrt
Flashing red (Record Ready)
Tch
Red (Recording)
Ltch
Read Green
Off Off
USER DEFINED KEYS [5] + AUTOMIX [WRITE], [TOUCH],
[LATCH], [TRIM], [READ], or [OFF]
USER DEFINED KEYS [5] + USER DEFINED KEYS [4] + AUTO-
MIX [WRITE], [TOUCH], [LATCH], [TRIM], [READ], or [OFF]
[AUTO] Button Indicators
Do this!