LEMKEN Saphir 8 AutoLoad Operating Instructions Manual page 67

Operation
7
Push both sowing shaft halves further in, mount the coupling (6), and mount the
linch pins (3, 5, 8, and 9) as previously.
Place the pull grip back in the holder and secure with the linch pin.
6
5
Important! You must take a new calibration test sample following each seed
wheel change.
Dismantle the linch pin (8), place the pull
grip on the outer right of the right-hand so-
wing shaft (7), and secure with the linch
pin.
9
Dismantle the linch pin (9) and pull out the
right-hand sowing shaft (7).
Remove the seed wheels (e.g. Conti Plus)
and replace with different seed wheels
(e.g.
wheels must always be replaced with
other switchable seed wheels.
Important! All seed wheels must be moun-
7
8
Mono Plus). Switchable
ted in the same way, i.e. re-
cesses and other distinctive
points must be in a line.
3
seed
65